29-6-14, Bought a racing seat yesterday.
Roll Frame design rough drawing:
-> Motor Control (Motor selection, Motor controllers, software interface, Emergency stop + reset)
-> Sim Software (Needs to work with Occulus + head tracking + motors)
-> USB joystick (+ rudders)
-> Hardware (bearings/shaft electrical connections/frame design + construction)
having the graphics computer rotating with the seat or outside the apparatus:
inside (most likely):
-HDMI direct to occulus.
-Only motor data and power connections from computer through rotating electrical contacts.
-possibly requires SSD for computer due to motion.
-Motor Control hardware either inside or outside frame connected to computer via (x-sim?!) USB industrial motor controller? + Secondary motor backup control outside frame.
-requires running HDMI and USB through rotating electrical contacts
-only require 1 computer for all controls
Having motor controllers outside Vs 1 in for roll and 1 out for pitch
1 inside (with computer inside):
-mains voltage coming in to pitch motor.
-Roll motor controller connects direct to computer, pitch control signal goes outside.
Both outside (computer inside with motor control signal going through inter connects):
-Roll motor current cables going through interconnects.
-Motor control data going out through slip-ring.
-Also requires power for computer coming in through slip ring.